JOURNAL OF THE JAPAN SOCIETY FOR TECHNOLOGY OF PLASTICITY
vol.42 no.491 December 2001
―――CONTENTS―――
Essays
-
Proposal on the Activation of JSTP
Hiroshi IKE
Page 1(1177)
-
Metal Forming―An Enabling Technology―
KOPP, R.
Page 2(1178)
Explanations
-
Micro Cellular Foam Molding Utilizing Super Critical Fluid
Fumiaki TSUDA
Page 4(1180)
-
Process-Tribology of Difficult-to-Deform Materials
Tamotsu NAKAMURA
Page 10(1186)
-
Introduction of Water Jet Cutting Technology and Its Manufacturing Researches and Applications
Shin-ichi WARISAWA
Page 17(1193)
-
Running Shear Fracture Propagation of High Pressure Gas Pipeline and a Guideline to the Fracture Control
Toshiya AKIYAMA
Page 22(1198)
Papers
-
Improvement of the Tooth Trace Accuracy of Spline
――Spline Rolling of Deep-Drawn Cups IV――
Ryoichi MATSUNAGA, Tatsuo OZAKI,
Teruie TAKEMASU and Hiroshi MIYAHARA
Page 27(1203)
-
Consolidation of Surface Layer and Improvement of Surface Durability
of Sintered Fe Alloy Rollers by Finish Rolling
Teruie TAKEMASU, Tatsuo OZAKI, Hiroshi MIYAHARA,
Shigeru HOYASHITA, Michiharu YOKOI and Hiroshi INADA
Page 32(1208)
-
Limitation of Dieless Forming Technique and
Application to Triple-Layered Heat Exchangers
――Dieless Forming Technique for Double-Layered Heat Exchangers III――
Toshiyuki AMIMOTO, Satoru KIMOTO,
Masaru KUNIKATA and Hiroya MURAKAMI
Page 37(1213)
-
In Situ Measurement of Interface between Tool and Workpiece under MPH Lubrication
by Means of Direct Fluorescence Observation Technique
Akira AZUSHIMA and Toshiyuki IDEUE
Page 42(1218)
-
Analysis of Forming Process for Foam Products
Made from Waste Glass Powder
Kazunari SHINAGAWA, Takayoshi KANEKO,
Mikio NAKASHIMA and Yasushi HIRASHIMA
Page 47(1223)
-
Effect of Blank Shape and Hydraulic Counterpressure on
Deep Drawing Limit of Rectangular Shells
Kazuhiko NAKAMURA and Haruhiko SUGATA
Page 52(1228)
-
A Scheme for Volume Loss Recovery and Incremental
Volume Control in Non-Steady State Metal Forming Analyses by
Rigid-Plastic Finite Element Method
Shiro TOYOSHIMA, Jian SHANG and Manabu GOTOH
Page 57(1233)
-
Theoretical Analysis of Roll Profile by a Two-Roll Straightening Technique
――Greater Straightening and Lower Residual Stress Technology of Bar Products II――
Yousuke NISHIKORI, Motoo ASAKAWA,
Tokukatsu SUZUKI, Taku YANAGIHASHI and Takayuki HAMA
Page 62(1238)
-
Optimization of Bending Condition for Dieless U-Bending Process
――Development of Dieless Bending Process for Precision-Bent Tube II――
Takashi KUBOKI and Munekatsu FURUGEN
Page 67(1243)