JOURNAL OF THE JAPAN SOCIETY FOR TECHNOLOGY OF PLASTICITY
vol.42 no.483 April 2001
---CONTENTS---
Essay
- Hope for Precision Metal Forming
Atsushi DANNO
Page 1(279)
Explanations
- National Project on Super Metal
Yoshiyasu SHIROTA and Katsusuke NAGAHAMA
Page 2(280)
- Present Status of 800MPa Steel Research in the STX-21 Project
Shiro TORIZUKA, Kotobu NAGAI and Akira SATO
Page 9(287)
- Attempts of Improving Ultrasonic Drawing
Masao MURAKAWA and Masahiko JIN
Page 15(293)
- CLaser Cladding: The State of the Art and Application
to the Cylinder Head Made of Aluminum Alloy
Hidenobu MATSUYANIA, Kimihiro SHIBATA, Makoto KANO and Ryuji NINOMIYA
Page 21(299)
- Roll Surface Temperature and Heat Scratch in the Hot Rolling of Aluminum Sheet
Takeshi YONEYAMA
Page 27(305)
Explanations
- Practice Lesson for Promotion of Creation in the Curricula for Teacher
Training of Technology Education
Fumitaro SEKINE
Page 33(311)
Lecture
- Mechanics of Powder Compaction and its Application to Compaction Processes
Susumu SHIMA
Page 38(316)
Papers
-
Forming Characteristics in Hole Flanging with Ironing on Thick Metal Plate
Ryosuke IMASEKI, Yukihiko UCHIDA and Michihiko HOSHINO
Page 45(323)
-
Improvement of Pure Stretchability by Overlapping Sheet Metals
Masanori KOBAYASHI, Nobukazu HAYASHI and Yasushi KUROSAKI
Page 50(328)
-
Free-Tension Setup System for Bar Rolling Based on Fuzzy Inference
Harutoshi OGAI, Yukio NOGUCHI, Akira FUJII, Kanji BABA,
Makoto BABA and Hitoshi ISHII
Page 55(333)
-
Development on Bending and Torsion Combined Forming Machine
for Rectangular Cross-Section Conductor
Naozumi HATADA, Keii UENO, Makoto TATEMURA, Shinobu WATANABE,
Keiichi NAKAMURA, Michio TAKAHASHI, Shinsaku IMAGAWA and Osamu MOTOJIMA
Page 60(338)
-
Characteristics of Burr-free Blanking Method Utilizing Large Negative Clearance
Kenji HIROTA and Kazuyoshi KONDO
Page 65(343)
-
Determination of Forming Conditions and Optimization of Wall Thickness Distribution of Ring in Rotary Forging of Large Wheel Disks for Trucks and Buses by Finite Element Simulation
Osamu EBIHARA, Ken-ichiro MORI,
Kenji YOSHII, Hiroshi TAKAHASHI and Masahiro ABE
Page 70(348)