JOURNAL OF THE JAPAN SOCIETY FOR TECHNOLOGY OF PLASTICITY
vol.42 no.482 March 2001
---CONTENTS---
********* Special Issue on Present State and Future Problems of Composite Materials Technology *********
Essay
- Fusion of Materials Science and Technology of Plasticity
Yoshihiro SAITO
Page 1(167)
Review
- Current Status and Future Development of Manufacturing Technologies for Clad Steel
Takao KAWANAMI
Page 2(168)
Explanations
- Mashy-State Rolling of Sheet Metals Laminated with Composite Layers
Manabu KIUCHI and Sumio SUGIYAMA
Page 7(173)
- Production Method of Graphite Containing Sintered Bearings by Powder Rolling
Shinji YAMADA and Takashi KIKKAWA
Page 13(179)
- Research on Cladding of Metals by Hot Rolling in Vacuum
Hiromi MATSUMOTO and Toshio KIKUMA
Page 19(185)
- Cladding by Cold Rolling in Vacuum
Kinji SAIJO
Page 25(191)
- Introduction for the Manufacturing Process and Application of Explosion Bonded Clad
Etsuji KAKIMOTO
Page 30(196)
- Metallurgical Behavior of Cladding Interfaces
Mitsunobu ABE
Page 35(201)
- Manufacturing of Roll Bonded Clad Steel and Characteristics of Bonding Strength
Yoshihiko YAMAMURA and Takashi FUKUDA
Page 40(206)
- Production Technology of Roll-Clad Steel Plates
Hideto KIMURA
Page 45(211)
- Development of Hot Rolled Titanium Clad Steel Coil Using Liquid Phase in the
Interface of Both Metals for Joining
Akio YAMAMOTO
Page 52(218)
- Development of Dissimilar Metal Transition Joint by Hot Bond Rolling
Hiroyuki KUROKAWA, Kazuyuki NAKASUJI, Takayuki NAGAI and Tsutomu KOIZUMI
Page 57(223)
Explanation
- Education of Metal Forming in Junior High School
Masahiko HORIHATA
Page 62(228)
Lecture
- Powder Injection Molding MIM & CIM
Yoshimitsu KANKAWA
Page 66(232)
Report
- Impression of Asian Academy Seminar on Advanced Manufacturing System
and Hyderabad, India
Kunio HAYAKAWA
Page 72(238)
Papers
Rapid Publication